Product Detail

 

DRX Marking Manual

1. Set a marking kit on the part of your uniform where you want to mark it. You have to put the clear film up.
2. Check the back of the kit and uniform that they are clean.
3. Set an iron and put the dial ‘wool’. (Heat it for about 5 minutes.)
4. Stick it a little bit so that it cannot go out from the place.
5. Iron it with tight about 10 seconds evenly.
6. Don’t rub. Just press it.
7. If the kit is long, iron one part at a time depending on the size of iron.
- If the iron is not hot enough, the kit cannot be stuck.
- If the iron is too hot, it can damage the uniform.
8. After cooling the kit, remove the film from the edge.
9. Finish.* If there is a part not to stick, put on the clear film and iron it a little bit.

 

 

※ Errors may occur depending by measuring method.